Atlas AA240 Owner's Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7 AtlasSound.com
Specifications are subject to change without notice.
Owner’s Manual AA240 Mixer Amplifier
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
Front Panel Description
1. Power Switch
This push on / push off switch applies power to the AA240.
2. Power LED
This LED will illuminate blue when the AA240 is turned on.
3. Peak LED
The PEAK LED will illuminate Red when the AA240 is in a clipping condition, caused by excessively high input levels or a GAIN con-
trol is turned up too high. An occasional flash is OK.
4. Limit LED
This LED will illuminate Yellow when the amplifier is consuming excessive current. At that point, a limiting circuit is being activated,
preventing the amplifier from failure. The most likely cause for the fault is an incorrect load impedance on the output of the ampli-
fier. The LED should never come on if a proper load is applied.
Note: An occasional LED flash is okay. When LED is ON audible distortion may be heard at the speakers.
5. Signal LED
This LED will assist you in setting gain structure into the amp. With a source connected to the amp and playing, turn up the chan-
nel gain control until this LED just starts to flash green. Once all the sources connected are playing, the SIGNAL LED may be on
solid. This condition is normal.
6. Master Gain Control
The MASTER GAIN CONTROL will raise or lower all the input channels together. A good starting point for setting gain structure is
to set MASTER GAIN CONTROL at the 12:00 position, and then adjust the individual channels one at a time.
7. Input 1-6 Controls
The gain for input channels 1-6 are controlled by these rotary controls. The MASTER GAIN CONTROL must be turned up in addition
to the input controls for audio to be present at the speaker terminals.
8. Bass Control
The BASS CONTROL is a shelving type control which will boost or cut bass frequencies at 100Hz at the rate of ±6dB.
9. Treble Control
The TREBLE CONTROL is a shelving type control which will boost or cut treble frequencies at 10kHz at the rate of ±6dB.
10
0
10
0
0 10
On
Off
Input 6
Input 5
Input 4
Input 3
Input 2
10
0
10
0
10
+
0
Bass
Treble
0
10
+
Input 1
Master
Power
PowerLimitPeakSignal
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments