Atlas Guardian Pro 180 Series User Manual download pdf (Page 2)

598-1092-02

INSTALLATION

For easy installation, select an existing light with a wall

switch for replacement.

For best performance, mount the ﬁxture about 8 ft. (2.4 m)

above the ground.

NOTE:

If ﬁxture is mounted higher than

8 ft. (2.4 m), aiming the sensor down will reduce coverage

distance.

For eave mount only:

❒ Swing the sensor head towards the clamp screw

joint.

If the sensor pops out of the ball joint, loosen the

clamp screw and push the sensor back into the ball

joint. Tighten the clamp screw when done.

❒ Then rotate the sensor head clockwise 180° so the

controls face down.

Controls

Wall Mount Eave Mount

For under eave installation, the sensor head must

be rotated as shown in the next two steps for proper

operation and to avoid the risk of electrical shock.

Controls

Clamp Screw

Move ON-TIME Switch to

1, 5, or 10 minutes

Mode Switching Summary

Flip light switch off

for one second then

back on*

MANUAL MODE

AUTO

TEST

* If you get confused while switching modes, turn the

power off for one minute, then back on. After the cali-

bration time the control will be in the AUTO mode.

1 2 3 4 5 6 7 8

No comments

Atlas Guardian Pro 180 Series User Manual Page 2