Atlas Guardian Pro 180 Series User Manual download pdf (Page 3)

598-1092-02

❒ Remove the existing light ﬁxture.

❒ Install the mounting strap as shown using two screws

that ﬁt your junction box.

❒ The plastic hanger can be used to hold the ﬁxture

while wiring. The small end of the plastic hanger

can be threaded through the hole in the center of

the cover plate. The small end then goes into one

of the slots on the mounting strap.

❒ Route the light control’s wires through the large

gasket holes.

❒ Twist the junction box wires and ﬁxture wires together

as shown. Secure with wire connectors.

White to

White

Black to

Black

Junction box ground wire to

green ground screw on ﬁxture.

Gasket

Mounting

Strap

Mounting

Bolt

Rubber

Plug

Mount the Light Control

❒ Align the light control cover plate and cover plate

gasket. Secure with the mounting bolt.

❒ Push the rubber plug ﬁrmly into place.

❒ If a wet location junction box was not used, caulk

the wall plate mounting surface with silicone

weather sealant.

Lock Nut

To avoid water damage and electrical shock,

keep bulb holders 30° below horizontal.

❒ Adjust the bulb holders by loosening the lock nuts but

do not rotate the bulb holders more than 180° from

the factory setting. When screwing in the ﬂoodlamps,

do not overtighten.

Keep bulbs at least

1" (25 mm) from the

sensor. Do not allow

the bulbs to block

the lens.Lens

Wire the Light Control

WARNING: Turn power off at circuit breaker

or fuse.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Atlas Guardian Pro 180 Series User Manual Page 3

Comments to this Manuals

Related products and manuals for Motion detectors Atlas Guardian Pro 180 Series